Frigidaire Washer — Error Code E11

Q: How do I fix the E11 error on a Frigidaire washer?

Try first: Restore the incoming water flow. Open both supply valves fully, straighten kinked inlet hoses, clean the inlet screens, verify household pressure, then power-cycle for one minute and retry.

The fill time is too long.

brand Frigidaire appliance Washer market US component water inlet valve category water_supply severity stop failure

ApplianceDB ranks 2 repairs for this code, led by “Restore the incoming water flow”. That top fix is an easy DIY job, involving the water inlet valve. Severity is classified as stop failure — the appliance halts until the fault clears.

Ranked repair steps

1. Restore the incoming water flow

Open both supply valves fully, straighten kinked inlet hoses, clean the inlet screens, verify household pressure, then power-cycle for one minute and retry.

easy · basis: cost ascending

Remedy source: ApplianceCodeHub — Frigidaire Washer E11 Guide (fix layer)

2. Replace the inlet valve

If fills stay slow, replace the water inlet valve assembly and check the pressure switch and its hose.

advanced · basis: cost ascending

Remedy source: ApplianceCodeHub — Frigidaire Washer E11 Guide (fix layer)

Provenance: facts re-derived from a disclosed repair reference — ApplianceAid — Frigidaire Front-Load Washer Fault Codes. Meanings and steps are original paraphrase; nothing is reproduced verbatim.