Whirlpool Washer — Error Code F9E1

Q: How do I fix the F9E1 error on a Whirlpool washer?

Try first: Clear the drain path. Straighten or unclog the drain hose, fit the U-shaped form, keep the standpipe between 39 and 96 inches, and use HE detergent.

Draining is taking longer than expected (over about eight minutes).

brand Whirlpool appliance Washer market US component drain pump category drainage severity stop failure

ApplianceDB ranks 2 repairs for this code, led by “Clear the drain path”. That top fix is a moderate-difficulty DIY job, involving the drain pump. Severity is classified as stop failure — the appliance halts until the fault clears. 1 OEM replacement part is documented for the repairs on this page, including Washer Drain Pump.

Ranked repair steps

1. Clear the drain path

Straighten or unclog the drain hose, fit the U-shaped form, keep the standpipe between 39 and 96 inches, and use HE detergent.

moderate · basis: manufacturer first

2. Replace the drain pump

If the drain path is clear and draining still exceeds eight minutes, disconnect power and water, open the access panel, and replace the drain pump.

advanced · basis: cost ascending · parts $80.83–$122.93 (2026)

Replacement part (exact OEM numbers)

WPW10730972 — Washer Drain Pump · observed $80.83–$122.93 (2026)

Prices are dated retailer observations, never estimates. Verify model fitment before ordering.

Provenance: facts re-derived from an official manufacturer listing — Whirlpool Product Help — Error Codes in Front Load Washers. Meanings and steps are original paraphrase; nothing is reproduced verbatim.