Códigos de error de secadora
40 códigos verificados. Cada página muestra el significado, el componente implicado, las soluciones priorizadas y la fuente de la que se obtuvo.
- LG D80 — Airflow through the exhaust duct is restricted by roughly eighty percent.
- LG D90 — Airflow through the exhaust duct is restricted by roughly ninety percent.
- LG DE — The door is not fully closed or is obstructed.
- LG E05 — A water-supply problem affected the steam cycle.
- LG E13 — The drain hose is kinked or clogged, or sump water has frozen on condensing mode
- LG E21 — Tub drainage took too long on condensing or steam models.
- LG F0 — The lint filter is missing or not seated correctly.
- LG GAS — No gas supply is reaching the burner on gas models.
- LG HS — The moisture (humidity) sensor is faulty, extending drying time.
- LG NP — No current is being sensed at the heater, usually a home wiring or supply issue.
- LG PF — Power to the dryer was interrupted and a reset is required.
- LG PS — Improper voltage at the power cord, typically from reversed terminal wiring.
- LG TE1 — The primary temperature thermistor is reporting a fault.
- LG TE3 — A secondary temperature thermistor is reporting a fault.
- Samsung 3C — A drive-motor fault was detected.
- Samsung 9C1 — The voltage supplied to the dryer is abnormal.
- Samsung AC — Internal control modules cannot communicate with each other.
- Samsung BE — A control-panel button is being sensed as stuck.
- Samsung C80 — The exhaust vent is roughly eighty percent blocked.
- Samsung C90 — The exhaust vent is more than ninety percent blocked.
- Samsung CLG — The exhaust vent is clogged.
- Samsung CT — The ambient temperature is outside the operating range.
- Samsung DC — A fault was detected with the door, latch, or door sensor.
- Samsung FC — The power-source frequency is invalid.
- Samsung HC — The dryer is overheating.
- Samsung HC2 — A gas-ignition fault was detected on gas models.
- Samsung OD — The load did not dry within the expected time.
- Samsung TS — The temperature-sensing circuit reported a fault.
- Whirlpool AF — Airflow through the venting system is restricted.
- Whirlpool F01 — The primary control board failed.
- Whirlpool F02 — The keypad or user interface failed.
- Whirlpool F06 — A door lock fault was detected.
- Whirlpool F20 — A heating element fault was detected.
- Whirlpool F24 — A communication fault was detected.
- Whirlpool F25 — A communication fault was detected.
- Whirlpool F26 — A motor drive fault was detected.
- Whirlpool F29 — A moisture sensor fault was detected.
- Whirlpool F30 — Airflow is restricted in the venting system.
- Whirlpool F31 — Low or no line voltage was detected.
- Whirlpool PF — A power failure interrupted the drying cycle.