Hoover Washer — Error Code E01 (UK)

Q: How do I fix the E01 error on a Hoover washer?

Try first: Check the door and reset. Close the door firmly until it clicks, clear debris from the seal, and disconnect power for five to ten minutes before retrying.

The door lock (or drum-brake safety device on older collector-motor models) is not engaging correctly.

brand Hoover appliance Washer market UK component door interlock category door_lock severity stop failure

ApplianceDB ranks 2 repairs for this code, led by “Check the door and reset”. That top fix is an easy DIY job, involving the door interlock. Severity is classified as stop failure — the appliance halts until the fault clears.

Ranked repair steps

1. Check the door and reset

Close the door firmly until it clicks, clear debris from the seal, and disconnect power for five to ten minutes before retrying.

easy · basis: cost ascending

Remedy source: ApplianceCodeHub — Hoover Washer E01 Guide (fix layer)

2. Replace the door lock

If the error persists, have the interlock tested for continuity during the lock command and the door lock assembly replaced; check the control board if it continues.

professional only · basis: cost ascending

Remedy source: ApplianceCodeHub — Hoover Washer E01 Guide (fix layer)

Provenance: facts re-derived from a disclosed repair reference — Whitegoods Help — Hoover Washing Machine Error Codes. Meanings and steps are original paraphrase; nothing is reproduced verbatim.